Liberty'05 CRD kirjoitti:Onko kukaan saanut homelink systeemiin perustuvaa autotallin oven avaajaa toimimaan?
Ainakaan oma autotallin oveni ei totellut eli auton lähettimen koulutus ei onnistunut taitaa olla eri taajuudet käytössä.
Itse en ole kokeillut parittaa Homelinkkiä, mutta ainakin kahdet erilaiset ohjeet olen löytänyt toimenpiteeseen:
1.1
Sit in your driver's seat with your ignition key and garage opener remote. Insert your key into the ignition and turn the key to the "On" position.
2.2
Press and hold the two outer buttons on your HomeLink system (in your car) until the LED light on the HomeLink system starts blinking.
3.3
Hold your garage opener remote 2 inches away from the HomeLink system and press and hold both the "Open" button on your garage remote and the button you would like to program on the HomeLink system.
4.4
Hold both of the buttons until the HomeLink LED light starts flashing more rapidly and then release them.
5.5
Press and hold the "Trained" button on your HomeLink system and release this button once the LED light turns off on the HomeLink system. This will end the programming sequence.
VAIHTOEHTO 2:
1.1
Sit in your Jeep with the engine off. Press the first and third buttons on your Homelink system at the same time and hold them down for 20 seconds. The electronic vehicle information center (EVIC) will display "Clearing Channels." As soon as the message changes to "Channels Cleared," release the buttons.
2.2
Select one of the three Homelink buttons to train. Your Homelink system can hold up to three garage door codes. Hold the garage door remote 1 to 3 inches away from your EVIC, and press the selected Homelink button and the garage door remote button simultaneously. The EVIC will display "Training." When the training is successfully completed, the message will change to "Trained," and you will hear a beep.
3.3
To train additional Homelink buttons to open other garage doors, repeat step two.
4.4
If your training is unsuccessful, your garage door opener has a rolling code for security and requires additional training steps. Go to the garage door motor and find the "Smart" or "Learn" button, usually located near the antenna. Press the button, and immediately return to your Jeep and press down the Homelink button that you programmed for two seconds. Release the Homelink button, and then press it and hold it down for two seconds again and release it. At this point, the Homelink system may be programmed, but some brands of garage door openers require a third press and release, so press it down a third time for two seconds, and then let it go.
•Jeep recommends replacing the battery in the garage door opener that you use to program your Homelink system for best results..
•If you are having trouble programming Homelink, check the frequency of your garage door opener. Homelink works with devices operating at radio frequencies between 288 and 399 megahertz..
•In order to program in one new garage door opener code to Homelink, all of the Homelink buttons need to be reprogrammed..
•If you are selling your Jeep and want to erase your garage door codes, simply press the first and third Homelink buttons simultaneously for 20 seconds to clear the channels until the EVIC displays the message "Channels Cleared.".