WK SKREEM 'customer learn' tila

[rulppa]

Onkohan tämä avaimien opetus/koodaus poistettu käytöstä autoista jotka tulleet eurooppaan? Jos, saako tuon tilan vielä pelattua jotenkin takaisin? Eli pitäs toimia näin:

a) Close hood.
b) Insert one of the two valid Sentry Keys into the ignition switch and turn the ignition switch to the ON position.
c) After the ignition has been activated for more than 3 seconds (but no more than 15 seconds), cycle the ignition switch back to the "off" position. Remove the key and keep it at least 2' from the ignition switch.
d) Within 15 seconds of removing the first key, insert the second valid Sentry Key into the ignition switch and turn the ignition switch to the "on" position.
e) Approx. 10 seconds after the ignition has been activated by the second Sentry Key, the dash theft-security light will start to flash, and a single audible chime (not the key-in cylinder chime) will sound to indicate that the system has entered the "Customer Learn" programming mode.
f) Cycle the ignition switch back to the off position. Remove the key and keep it at least 2 feet away from the ignition switch. Theft-security light will turn off.
g) Press and release the programming button located on the custom harness.
h) Within 60 seconds, press the start button on the RS transmitter 2 times.
i) Approx 10 seconds after completion of step H, a singler audible chime will sound and the theft-security light will stop flashing and stay on solid for 3 seconds, and then turn off to indicate that SKREEM Interface module has been successfully programmed.
j) The system will remote start the engine approximately 15 seconds after step (h). Press the brake pedal to shut down the remote start system.

..moparin omaa kaukokäynnistystä koitan saada toimimaan, vaan kaatuu tuohon etten saa autoa customer learn moodiin .. vinkkejä?

[JAMANT]

Ilmeisesti toiminto puuttuu Euroopan tuonti -malleista, koska en ole minäkään saanut avainten ohjelmointi modea päälle, toiminto puuttuu....